måndag 15 september 2014

Drake Water Cooled 1947 Knuckle Engine


Harley 1933 500cc Speedway Engine

Stolen from KIOTEE GARAGE BLOG.
http://kioteegarage.blogspot.se/

"This is the history part.  The same guy that is selling the JAP also is selling a Harley Davidson 500 cc single race engine which is one of the prototype engine built to run against the JAP.  The buy it now price is $199,000.00.  Yes I read and typed that correctly.  This is what the seller says about the engine.


Circa 1933 one-off Harley Davidson Over Head Valve 500cc, 30.50 cubic inch single cylinder racing engine.  This experimental engine is the predecessor of the Harley Davidson CAC 500cc Speedway single racers.  This engine is a virtual copy of the J.A. Prestwich, also known as J.A.P. Speedway 500cc, 4 stud racing engine manufactured in Tottenham, England from the teens to the 1960's.  The J.A.P. Speedway machines were beating all comers including Harley Speedway racers.  The Harley racing department decided it was time to even the score.  A brand new J.A.P. 4 stud Speedway machine was purchased by the Harley race department.  Their express purpose was to dismantle and reverse engineer the OHV J.A.P. engine to improve Harley's raing performance by incorporating some of the J.A.P. designs. 

William Harley and Joe Petrali, scratch built this one-off Harley Speedway engine copying a J.A.P. single in the Harley race department.  William Harley told Petrali to discard the J.A.P. parts. but soon realized they could reuse the carburetor and magneto off the J.A.P. engine.  He asked Joe what became of the carb and mag?  Joe replied he threw them in the trash as instructed.  Harley told him to go retrieve them, which he did.  The original Amal racing carburetor and the Lucas racing magneto were found and installed on this Harley one-off racing engine.  They remain in use on it today.

The Harley Davidson engine turns over and has  good compression.  This is the original untouched engine as given to Joe Petrali by William Harley at the end of their project.  At the base of the cylinder, "EX 1320" is cast indicating it is an experimental item.  The brand name, "Harley Davidson"  is in bas relief on the rocker box cover similar to where the J.A.P. engine has J.A.P. in bas relief.  Other than "EX 1320" cast on the cylinder and "Harley Davidson" in bas relief on the cover, there are no VIN , line bore, or date code numbers.  The engine case castings are rough and crude where reinforced around the crankpin.  The compensating sprocket is on the sprocket shaft.  Use as a show engine or build a truly one of a kind Speedway racing machine."


Det är dax att tänka till lite igen . . . 

Brooken Spooke 

fredag 18 juli 2014

JD - LAKE Injector 38mm - Brooken Spooke

video
video
The LAKE Injector works fine- for racing. But too rich mixture at low rev for city crusing. From half throttle, 1000rpm and up it kikks ass. But its a spark plug eater if you aint reving it.

Ride on . . .

måndag 14 juli 2014

Back home from North West Asia

Back home from  the North West Asia. Big warm thank you to all guest, friends and holders of the amazing event and party that i never will forget. - Brooken Spooke